14-09-2021

Arming the motors and Disarming the motors

Arming the motors

Arming the vehicle allows the motors to start spinning. Before arming, make sure all people, objects, and any body parts (e.g., hands) are clear of the propellers. Then do the following:

Note

You can only arm or disarm in Stabilize, ACRO, AltHold, Loiter, and PosHold modes. You cannot arm your copter in AUTO mode. The AUTO_OPTIONS parameter can be used to alter this behaviour, allowing arming while in AUTO mode, and/or, allowing a mission takeoff command to start upon AUTO mode entry, even if the throttle has not been raised.

  1. Turn on your transmitter.
  2. Plug in the LiPo battery. The red and blue lights should flash for a few seconds as the gyros are calibrated (do not move the copter)
  3. The pre-arm checks will run automatically and if any problems are found the RGB LED will blink yellow and the failure will be displayed on the ground station. Please refer to this page
  4. Check that your flight mode switch is set to Stabilize, ACRO, AltHold, Loiter, or PosHold
  5. If using a autopilot with a safety switch, press it until the light goes solid
  6. If you are planning on using an autonomous mode (i.e. Loiter, RTL, Auto, etc) swith the vehicle to Loiter or PosHold and wait until the LEDs blink green indicating a good GPS lock
  7. Arm the motors by holding the throttle down, and rudder right for 5 seconds. Do not hold the rudder right for too long (>15 seconds) or you will begin the AutoTrim feature
  8. Once armed, the LEDs will go solid and the propellers will begin to spin
  9. Raise the throttle to take-off

Note

If you leave the throttle at minimum for 15 seconds while in any of the above modes the motors will automatically disarm.

Disarming the motors

Disarming the motors will cause the motors to stop spinning. To disarm the motors do the following:

  1. Check that your flight mode switch is set to Stabilize, ACRO, AltHold, Loiter, or PosHold
  2. Hold throttle at minimum and rudder to the left for 2 seconds
  3. The LED will start flashing indicating the vehicle is disarmed
  4. If using a autopilot with a safety switch, press it until the LED begins flashing
  5. Disconnect the Lipo battery.
  6. Turn off your transmitter.


Okunma: 242

 FileIDName
Download5 
If you are unable to view file, you can download from here or download Adobe PDF Reader to view the file.
Etiketler : radiolink, disarmed drone, armed drone, drone,

Henüz yorum yapılmamış.

Yorum

  •  
  •   
  •  
  •  

Reklam

Kategoriler

Hakkımda

Ertuğrul Kıraç,1986'da İstanbul'da doğdu. B.evler'de yaşamaktadır.
Daha fazlası

En Çok Okunanlar

En Son Eklenenler